Moss Motors, Ltd

I am looking for a u shaped tube that goes from the exhaust EGR valve to the intake manifold on a 78 MG Midget. I need one of the nuts from it.  I have a 78 that someone removed the smog tube from the exhaust manifold down by where the header pipe bolts to the exhaust manifold, and I need something to plug the hole. Or if anyone has a plug ...

The alternator lamp is dim all the time on my 73 MG Midget.  I've checked the grounds, replaced the brushes and checke dteh tension on the belt. 

Does anybody know the Ohm range for the stock sending unit. Mine is long gone, and I want to install a RCI Aluminum Fuel Cell. The sending unit on this tank is 0-90 Ohms. Will it work on my stock Smith gauge?   Thanks Doug D

I've put together a little example page to show where the seatbelt mount points are in later Midgets. http://millenniumtree.com/share/midget/index.html Hope that helps.  We bought our '69 Midget without seatbelts.  The first and best $100 we spent was to buy 3-point belts. (# 222-206) The mount points hadn't been used in some time and ...

Hi all, I'm looking at doing some improvements to my braking system. I'm going to install the Frontline rear disc conversion kit from Moss. My question is on the front. Would changing the front discs to Cross drilled/slotted with ceramic pads be enough of an improvement or should I consider the 9'' conversion kit from Frontline? I drive in the ...

hey all i have a leaky situation ...when it rains heavy here water seems to get in my interior right in front of drivers seat just wondering how it is getting in there passagengers side is dry  i was thinking the seal around the door but it looks fine then i thought maybe the battery box has some holes and thought it might have come from ...

I am looking for all the deals for under bonnett resto The ones in particular i have not found are the ones on the fan shroud that contain timing information and such It would be nice if there was a complete SET availible Has any one seen anything like this  OH just about forgot this is on a 1979 midget 1500    My ground ...

Greetings all!  I have a problem with an otherwise (mostly) perfect restoration, and reading in this forum, I see that others have experienced this too but may not have found the cause.  Here are some of my observations. As a background, my '72 Midget (1275) has had a top to bottom restoration done on all of it and I've been ...

Hi, I am new to this site so here go’s. My Midget’s 1275 engine is running very lumpy. I bought it as a none runner. The distributor was off but in the boot ready to go on.Also, the twin Su’s were off and in the boot. I have now refit them and set the static timing. I now have the engine ticking over but very lumpy. I have tried ...

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:''Table Normal''; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:''''; mso-padding-alt:0cm ...