Complete Interior Kit, XK120 Roadster
WARNING: May contain chemicals that may cause cancer or reproductive harm.
Interior Kit, XK120 Roadster
Carpet Set
Deep-pile Wilton wool, cut and bound, with leather heel pads and leather shift-lever gaiter sewn in.
Carpet Underfelt Kit, Foam
All pieces are pre-cut for ease of fit.
Original-Specification Leather Front Seat Covers
Grain and color-matched, with Moquette backs; sewn, ready to install. Foams not included.
Original-Specification Leather Center Console Cover
Carefully grain- and color-matched; sewn, ready to install.
Center Console Base
Bitumen fiberboard, formed and riveted as original
Original-Specification Leather Handbrake Gaiter
Sewn and ready to install.
Door Panels (pair)
Complete panels in hardwood plywood, vinyl trimmed including original style pocket flaps with Tenax fasteners, includes small panels under main door panels (later cars only). Door panels are leather-covered for very early cars.
Original-Specification Leather Door Pulls/Lanyards
Leather pulls with original ring-end hardware sewn in
Door Opening Re-Trim Kit
As original Moquette-covered "J" rubber extrusions, one pair for "A" post and one pair for sills and plain Moquette covers for under "B" posts.
Door Panel Pocket Liners
Riveted fiberboard inner pocket inserts are flocked as per original specifications.
A-Post/Kick Panels
Pair of bitumen resin board panels, trimmed in vinyl, ready to install. Later cars have cut-outs for vents.
B-Post "Dog Leg" Panels
Pair of bitumen resin board panels, vinyl trimmed, ready to install.
Under-Dash Panel
Plywood panel is trimmed in vinyl and ready to install.
Rear Bulkhead Cover, Lower
Vinyl is pre-cut for vertical panel and panel around batteries.
Rear Bulkhead Cover, Upper
Vinyl is pre-cut for vertical panel and side-screen storage area.
Battery Box Cover
Pre-cut vinyl and foam ready to cover the battery box cover panel.
Dash Re-Trim Kit
Pre-cut leather and piping to re-trim the center panel and panels to the left and right of instrument panel.
Cockpit "D" Roll Kit
Pre-cut leather and piping; includes top-rail birch plywood support strips
Panel Above Instruments
Complete panel in bitumen resin board, vinyl trimmed, ready to install.
Panel Below Instruments
Complete panel in bitumen resin board vinyl trimmed, ready to install.
Wheel Arch Covers
Pre-cut vinyl and foam ready to cover inner body wheel arches
Boot Mat
Cut and bound, in wool carpet (early cars) or Hardura (later cars).
Boot Lid Panel
Hardwood ply panel, vinyl trimmed, including wood mount block for boot light.
Miscellaneous, Pre-Cut Trim Covers:
- - Under-dash plywood triangle panel covers, vinyl (pair).
- - Headlight dip switch base cover, Moquette.
- - Transmission inspection plate cover, vinyl.
- - Hand brake base plate cover, vinyl
Black-Topped Carpet/Boot Mat Snap Set
Twenty-two sets; snap set tool included with trim kit.
Screws and Washers
Forty stainless steel screws (20 short and 20 long) plus original cup washers. Made in England.
The Longest in the Business
- All Classic British products are warrantied to be free from defects in material and workmanship for 2 years from the date of invoice.
- All superchargers, supercharger components, and supercharger hardware are warranted to be free from defects in material and workmanship for 1 year from date of invoice.
- Moss Motors, Ltd. will, at its discretion, repair or replace any part that fails in service within the warranty period. This warranty does not cover labor, failure of related components, normal wear of brake or clutch components or failure resulting from alteration, misuse, accidental damage, faulty installation, or faulty repair.
- Warranty requests should be submitted to our sales department and must be supported by the original Moss Motors purchase invoice and documentation of the failure.